Equipment Found

Item is a used Myno wine pump with reeves drive and controls. This is an older pump that was used in a winery for many years and has seen limited annual use. It is represneted to be in good shape and priced at a small fraction of new.

Item is a used, Coker model C328-MDG, S/S, centrifugal pump. Pump is powered with Baldor 71/2 HP, S/S motor turning @ 1750 RPM Pump has clamp style 3 x 2 ports and clamp on head.

Item is a used, Waukesha/SPX, model 060UI, positive displacement pump. This is the pump only. It is not currently matged to a drive, but this can be done at additional cost. The gear box on the pump has recently been rebuilt and the pump has not been put back into service since.

Item is a used Waukesha/SPX model 060)UI pump. This is the pump only. It is not currently mated to a drive. This can be done at additional cost. The gear case was recently rebuilt and the pump has not been put into service since.

Item is a used, Waukesha model 015-U1 positive displacement pump manufactured in 2014 .Pump has a built in pressure bypass and clamp style ports. This pump is set up for HAZARDOUS LOCATION operation. Motor, gearbox pump assembly is mounted on a S/S cart. It is powered with a 1 1/2 HP, explosion proof motor mated to a Reeves mechanical vary-drive and 9:1 gear box It is equipped with an A-B hazardous location enclosure for the motor contactor and ON/OFF switch. There is an indicator light on the enclosure to indicate power. The 20' power cord is equipped with a hazardous location plug end as well as a separate, clamp style ground lead.

Item is a used, Waukesha/CB, size 30, positive displacement pump. The pump is mounted on a mild steel base with a 2 HP, SEW motor/gear box. The gearbox is an SEW with a mechanical vari-drive. It has 1 1/2" ports. 230-460 volt/3 phase. Previous use was in food facility on cooking oil.

Item is a used, Waukesha/CB, size 130 positive displacement pump. Pump is currently mounted on a mild steel base with a 15 HP, SEW motor/gear box. The gearbox is SEW and is equipped with vari-drive. Previous use was cooking oil. 230/460-3 phase. Pump has 3" ports and is rated at approximately 150 GPM (.254 gals./revolution).

Item is a previously owned, 3" flexible impeller pump. The pump was only run tested with water (otherwise unused). The pump is an Inoxpa pump model RF 50/80 (tag indicates A Line pump). It has 3" ports and is currently set up for 460 volt/3 phase power. Pump is mounted on S/S cart w/motor controls. The RF pump is a flexible impeller pump. Due to the design, they are reversible self-priming pumps that can suction from a maximum height of 5 meters. This type of pumps can transfer products of both low and high viscosity as well as products containing particles or gases.. It is widely used for the transfer of wine, must and lees.